Skip to content

← All documentation

Post-install setup · Y2Reborn

Reborn UI v1 owner qualification

Documentation published by SchulzCode/Y2Reborn.

Instructions published by the project, shown here word for word.

Reborn UI v1 owner qualification

> **Historical record.** The dates, candidate identity, "current" claims, > next steps and permissions below belong to this recorded boundary. See > [current state](../CURRENT_REBORN_STATE.md) for the latest physically observed result.

Software candidate only. No screenshot, host test or ARM emulation result is a physical pass. Confirm the candidate hashes and exact required Platform v1 BOOTIMG before any owner-controlled installation. Ordinary review/update must preserve Y2DATA and all protected/factory partitions. This task does not flash. Use the Platform v1 owner sessions A–G for hardware prerequisites and record the actual boot/build IDs with results.

Record PASS/FAIL/NOT TESTED per item with exact candidate hash, output/peer/card, observed values and evidence path. Remaining hardware gates are not silently accepted because the UI can display them.

Published by the SchulzCode/Y2Reborn project [1] [3]